Medc Weatherproof FernTel User Manual download pdf (Page 10)

Plug the ribbon cable onto the pin contact strip (7) of the keypad plate.

Tighten the keypad plate (6) using four screws (8).

Table version

Place the telephone in the lower latches (A), swing it backwards until the upper latches

audibly engage (B).

Pull the telephone line through the cable gland (4) and connect it with terminal (5) TCP/La -

TCP/Lb.

Use cables with a sheath diameter of 5 to 9 mm only, otherwise the IP65 degree of

protection can not be guaranteed.

The standard handset accommodation (for the wall version) (9) can be replaced for the table

version.

After loosening the two screws (12) on the bottom of the keypad plate you can remove the

standard handset accommodation.

Fasten the table version handset accommodation (11) to the keypad plate by using the

included screws (12).

Plug the ribbon cable onto the pin contact strip (7) of the keypad plate. Tighten the keypad

plate (6) using four screws (8).

Lay the telephone cord according to the instructions, in order to prevent accidents.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

Medc Weatherproof FernTel User Manual Page 10