Medc Weatherproof FernTel User Manual download pdf (Page 13)

Programming

General

Use the Programming menu to modify the operating settings of the telephone. After lifting the

handset or pressing the disconnect key, a welcome message appears in the display.

Begin the programming procedure by pressing the

key.

In the top line of the display, the text „Main menu“ appears. In the second line, you see the

first menu item of the Main menu. The arrow > in front of the menu item indicates that this

item has been selected. Provided you have access to other menu items, pressing the

key

takes you to the next menu items, one at a time. Pressing the

key takes you back to the

top of the list of menu items.

The display shows a maximum of two menu items. When an arrow > is visible in front of an

item, it indicates that the item has been selected. The menu items denote further sub-menus.

Pressing the

key activates a selected menu item.

Any sub-menu may contain further sub-menus as menu items. These sub-menus are

selected in the same manner as in the Main menu. Press the

key to go to a higher menu,

or to leave the Main menu.

At the lower menu levels, so-called radio buttons are displayed for the selection of possible

settings.

Example:

Display Significance

---Activate--- Title line

(

) None Activated option

( ) Direct call Option

>( ) No calls Selected option

=== End=== End of menu list

Pressing the C key activates a selected option.

In certain menus, values may be changed. These changes are made by pressing the

and

keys.

For all programming goes: Changes are applied and stored upon pressing the

key only.

By pressing the

key, you leave the menu without applying the changes.

If a programming session has not been completed, the telephone leaves the Programming

menu after a certain amount of time (time-out).

If you want to modify the settings, you will be required to enter a four-digit PIN. The PIN set

by the factory is 0000.

Initial programming

In the as-delivered condition, the telephone already has a basic configuration enabling you to

make and answer calls. If you want certain settings regarding telephone book entries,

volume, dialling mode, or operation from private branch exchanges, you must use the

Programming menu.

Press the

key to go to the Main menu.

The sub-menu „Programming“ appears. Pressing the

key takes you to the next level,

where you may activate the sub-item „allow“ by pressing the C key. You will be prompted to

enter the PIN (factory setting 0000). Programming is now allowed, and the complete Main

menu is at your disposal, including the following items:

- Telephone book

- Short / Speed code dialling

- Settings

In order to

ram the tele

hone,

ou have to allow modifications of the settin

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comments to this Manuals

No comments

Medc Weatherproof FernTel User Manual Page 13

Comments to this Manuals

Related products and manuals for Sensors Medc Weatherproof FernTel